Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.The DLA-RS540 is a high performance, fully customizable home theater projector that produces exquisite quality images with a class-leading 130,000:1 native contrast ratio. For details, see page 11.įor each speaker (except for a subwoofer), connect the (–) and (+) terminals on the rear panel to the (–) and (+) terminals marked on the speakers. One center speaker to produce more effective surround effect (to emphasize human voices).Īfter connecting the speakers listed above, set the speaker setting information properly to obtain the best possible DSP (Digital Signal Processor ) effect.One pair of rear speakers to enjoy the surround effect.Two pairs of front speakers to produce normal stereo sound.If reception is poor, connect an outdoor single vinyl-covered wire to the AM EXT terminal.Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord.
Turn the loop until you have the best reception. Īdjusting the Surround Modes - Dolby Surround and JVC Īvailable DSP Modes According to the Speaker Arrangement. Storing the Basic Settings and Adjustments - One Touch Setting Center and Rear Speakers for the DSP Modes. Īdjusting the Front Speaker Output Balance. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.Ĭonsult the dealer or an experienced radio/TV technician for help. Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. The POWER switch in any position does not disconnect the mains line. Disconnect the mains plug to shut the power off completely.
0 kommentar(er)
